Report item
Item specifics
  • Brand Name: Kan.Do
  • Model Number: yellow DCS LCD
  • Place of Origin: Guangdong, China (Mainland)
  • GSM: 1800mhz
  • is_customized: Yes
Product Description

"Any dispute / Direct negative feedback"  before contact means "Buyer Rubbish " !! And not welcome such buyer !! Please go away !! ( Because business is cooperation ,not fight each other ) .

If protection time is running over ,please contact to extend time ,
if any problem found ,please contact to solve by a friendly way .


 

******Important Note ( please read , and please read all descriptions carefully ) ************:
To let a booster work it needs conditions :

1. please be sure that signal outside of your house is good enough to enable booster to work , what good signal is:

a). stand there to check if you can make fluent call or not,if can ,then you buy ,otherwise please dont buy ;
b). Put your phone there to check its signal strengthness :
Android : setting-about phone-status-network ,dbm display shall be at -60dbm to -75dbm around ;
IOS : dial *3001#12345#*, dbm display shall be at -60dbm to -75dbm around ;

-80dbm to -100dbm means bad,so please dont buy


2. Please be sure the place where you are going to install is DCS1800MHZ ,operator useS GSM 900MHz for 2G network in most areas, please check to clarify .

3. Buy correct cable and anteana ,50ohm cable is recommended ,RG58 not recommended , for DCS ,3G,4G you must use 50Ohm cable ;

4. Install them correctly to avoid interference ( auto osillation ) with walls between indoor & outdoor antenna, when interference exist ,LCD will display full signal bar or signal LED normal on, but phone can not make call .

For avoiding unhappiness ,please do not buy before you are clear about the above .



 

DCS 1800MHZ mobile phone signal amplifier,cellphone repeater/booster,   LCD display function ( below GSM model for reference how LCD display  )  :  

The 70 db shown in above picture is not real .

 

Real DCS model\'s LCD is as below :

 

Detaileds:

Voltage :  110-220V AC or DC5V 2A
Frequency range : 

                          1710-1785 ( UPLINK  )
                         1805-1880 ( DOWNLINK )

Gain :    

Uplink ≥58dBi         Donwlink ≥60db
Output power :  
                          Uplink:   20dbm
                          Donwlink :20dbm      

Outdoor signal strength request for outdoor antenna: at least -65dbm around ;
If you can have a android phone ,you can use it to test your signal strengthness as below :



For this product ,it will request signal strengthness not higher than -55dbm , if your signal strenght is worse to -55dbm ,it may work not good for you or not amplify signal for you .

 

PS.: -65 ,-70 and -80 dbm is worse signal than -60dbm ,-55dbm is better signal than -60dbm .


Impedance : 50Ω  ;
Seclusion  : >70db
Ambient temperature:-10oC--50oC

Configuration:   5V/ 2A prower

Size : 
Net weight : 0.36kgs .

Gross Weight  :0.46Kg  ( 0.5-0.6kgs after packing )

Signal coverage area :Max. support 500 sq meters. it will be different according to your using condition and the indoor antennas which you are using .
 

Note :
1. The product does not include accessories of cable , Heads and antennas , you need to buy them extraly, the list  only has power Adaptor included

 

Problems and solutions ( important ) , please read :

All booster will be tested before shipping to ensure quality , if you dont know any about booster and installation please start from 0 as below .

1. After power connected ,if LCD does not display or power LED is not on ,it means booster is defective ,kindly choose a friendly to solve it ,we accept to reship or refund. Andy dispute or negative will cause you on black list and an uncooperative solution ;

2. After you connet cables and antenna onto booster ,Lcd display 1-3 bars, you need to change your external antenna to a better place to gain stronger signal, if you use small pin antenna ,please upgrade it to a panel or a yagi ; If you can not find a place with good signal to enable booster with full bar display ,it means your outdoor signal is too bad ,booster will not work . So please kindly contact for a solution to return .

 

3. After you connet cables and antenna onto booster ,Lcd display full bar or signal LED is on ,but phone can not make call , it means big interference ( not booster quality problem ) which cause booster dead called auto osillation , so you need ( indoor and outdoor antenna can not see each other ) :
1). Use longer cable to enable outdoor antenna far away from booster and indoor antenna ;
2). Face outdoor and indoor antenna to different direction;
3). Get one or 2 walls between outdoor antenna and indoor antenna to ensure they are well insulated .
4). Check with your operator to ask what frequency are adopted in your area to ensure your booster matchs ( operator will use 900mhz in some area and use 1800mhz in an other area ) .


Detailed problems and solutions  :


If you still can not solve it yourself , you can friendly talk choose return or refund,
any dispute or negative mean buyer Rubbish !!

 

 

Below model for GSM900mhz 2G network ( IGC and ALC function ) may work under conditions :
1. bad outdoor signal at -80dbi to -85dbi around ;
2. No need wall to 100% insulate indoor and outdoor ( but if both antennas are too close ,it will not work too ) ,


http://www.aliexpress.com/store/product/digital-display-gain-65dbi-Auto-Gain-Control-GSM-booster-GSM-repeater-900mhz-booster-mobile-phone-repeater/601777_2031233344.html

 

http://www.aliexpress.com/store/product/digital-display-gain-65dbi-Auto-Gain-Control-GSM-booster-GSM-repeater-900mhz-booster-mobile-phone-repeater/601777_2031271457.html

 


http://www.aliexpress.com/store/product/Auto-Gain-Control-GSM-booster-digital-display-gain-65dbi-GSM-repeater-GSM-900mhz-booster-kits-w/601777_2031465046.html

 


http://www.aliexpress.com/store/product/Auto-Gain-Control-GSM-booster-digital-display-gain-65dbi-GSM-repeater-hone-booster-repeater-w-9/601777_2031466146.html

http://www.aliexpress.com/store/product/Auto-Gain-Control-GSM-booster-digital-display-gain-65dbi-GSM-repeater-mobile-phone-repeater-w-9/601777_2031464919.html

 


http://www.aliexpress.com/store/product/digital-display-gain-65dbi-Auto-Gain-Control-GSM-booster-GSM-repeater-mobile-phone-repeater-w-yagi/601777_2031271870.html

 


http://www.aliexpress.com/store/product/Auto-Gain-Control-GSM-booster-digital-display-gain-65dbi-GSM-repeater-mobile-phone-repeater-w-yagi/601777_2031451606.html


Above models is only possible to work if outdoor signal is not good (-80dbm) ,does not mean 100% to work if really bad outdoor signal ( because a booster will take many conditions ) .

When you buy them it means that you just want to take try ,if does not work ,please be friendly to solve. If you are going to direct dispute or negative, please dont buy .

 


 

Packaging Details
  • Unit Type: piece
  • Package Weight: 0.5kg (1.10lb.)
  • Package Size: 12cm x 12cm x 12cm (4.72in x 4.72in x 4.72in)
Shipping
Calculate your shipping cost by country/region and quantity.
Quantity: Ship to:
Packaging Details
  • Unit Type: piece
  • Package Weight: 0.5kg (1.10lb.)
  • Package Size: 12cm x 12cm x 12cm (4.72in x 4.72in x 4.72in)
Payment
We support the following payment methods. All payments made on AliExpress are processed by Alipay.